Skip to content
YujiElecs™ Controller and Control Panel for Smart 1250K-100000K Strip

YujiElecs™ Controller and Control Panel for Smart 1250K-100000K Strip

SKU YJ-OP4-8EN-PANNEL
$35.99 - $68.99
$35.99
$35.99
$35.99 - $68.99
$35.99

1. Installation & Wiring

Before beginning, ensure your power source is disconnected. This system is designed for 24V DC operation.

Step 1

Connecting Power to Controller

Connecting Power to Controller

Connect the controller to your 24V power supply following standard polarity:

  • Red Wire: Connect to the Positive (+) terminal.
  • Black Wire: Connect to the Negative (-) terminal.

Step 2

Connecting Controller to LED Strip

Connecting Controller to LED Strip

Connect your LED strip to the output terminals of the controller.

Please follow the specific channel-to-wire mapping below to ensure correct color and function control. Match the letters on the controller terminals with the corresponding wire colors on the strip:

  • Channel-Wire
    ---------------------------
    LED+ Black
    W- White
    C--
    B- Blue
    G- Red
    R- Green

2. Signal Pairing (Panel to Controller)

To sync your control panel with the controller, you must execute the following steps within 10 seconds of turning on the power.

How to Pair

  1. Turn on the power to the controller.
  2. Within 10 seconds, press the buttons quickly in this sequence:
    ON — ON — OFF — ON — ON
  3. The LED strip will flash, indicating that the pairing was successful.

How to Unpair (Reset)

  1. Turn on the power to the controller.
  2. Within 10 seconds, press the buttons quickly in this sequence:
    OFF — OFF — ON — OFF — OFF
  3. The LED strip will flash, confirming the connection has been cleared.

Customizable Setup

The standard kit includes:

  • 1x LED Strip Roll
  • 1x Controller
  • 1x Control Panel

If your project requires additional units, extra controllers and control panels can be purchased separately to expand your system.